PathPilot 2.0.2 adding rtlib's

I added and I think it works

Any of you guys using a parallel port? Curious what you bypassed.

DaOne wrote: Any of you guys using a parallel port? Curious what you bypassed.

That's how it works
@DaOne please share ini and hal only for XHC-HB04 !

dinkata wrote:

File Attachment:

File Name: charge_pump.so.tar.gz
File Size:2.15 KB

DaOne wrote: Any of you guys using a parallel port? Curious what you bypassed.

Code:

loadrt hal_parport cfg="0x378 out" setp parport.0.reset-time 500 loadrt charge_pump ...................... addf parport.0.read base-thread addf parport.0.write base-thread addf parport.0.reset base-thread addf charge-pump base-thread

That's how it works
@DaOne please share ini and hal only for XHC-HB04 !

No I understand the hal and ini files. Thats the easy part. When not in sim mode there is checks at startup (python code) that looks for the mesa card and then ethernet. It will error out and force close with a dialog box if they are not detected. its done in pathpilotmanager.py I am almost sure. I have not even touched the hal files or ini files in 2.0 yet. Gonna set through it before adding in all my mods to the python code. I just don't want to reinvent the wheel if someone else has done it already.

On the XHC-HB04 ini and hal files I would assume you do it just like you do in linuxcnc. I don't have one yet but might pick one up to play with for this lathe retrofit.

@Stigoe, dinkata:

Can you send me linuxcnc folder you're using to compile rtlibs? and instruction how to compile.

I can check what am i doing wrong.

My email: tuan302@gmail.com

I just put it Mesa 5i25 ....
then edit some files ....:woohoo: