My Newb Plasma Table Attempted Build

The latency just on the linuxcnc checker stays between 300k and 500k. Watchdog bites immediately after turning the machine on in linuxcnc.

I'm sure there's something that can be done, as I know a lot of people used this same PC. I'm running with a SSD and 8GB memory. The BRIX is UEFI though.

tommylight wrote: We need proof!
Pictures, video ?

Let's see if this works for viewing my short video.

1000ipm


drive.google.com/file/d/10aYepqBaxdmosjG...ob/view?usp=drivesdk

1200 ipm

drive.google.com/file/d/10arfKzPVowd5K1s...2e/view?usp=drivesdk

Nice !

Finished with the base machine in linuxcnc. Fastest I worked it for testing was 1200ipm. It seems like it will do a good bit more, but unnecessary for me to push it.

Now to just hook up the new machine torch to the plasma and then configure plasmac and do some test cuts.

Then I'll look into reducing the latency (as much as possible) on the BRIX S. Should be able to move my table configs over easily enough.

dvn4life1972 wrote: 1200 ipm

drive.google.com/file/d/10arfKzPVowd5K1s...2e/view?usp=drivesdk

Nice! But spend some time optimising the acceleration settings..