New Configuration Error

phillc54 wrote: This "should" have been fixed in v0.139 - 2020 Jun 24

Can you post the original .hal file csusing this issue?

If you mean the one before he ran configurator? I can get it, but it might be a day or two. He doesn’t go to his shop every day.

Yes, or the backup one created by the configurator in the new config directory

phillc54 wrote: Yes, or the backup one created by the configurator in the new config directory

No problem, I can get it... it’ll just be a few days probably.

Here's the original HAL.

It looks like configurator.py only checks for any line that has "spindle.0." in it, and comments it out.

The extra one that needs to be commented out is "sets spindle-at-speed true" in the section below, which is the section right below all of the setup spindle control signals that have the "spindle.0." in them:

That is a redundant signal anyway as it is only connected to spindle.0.at-speed and the default is True.

Maybe I should just comment out any line with spindle or SPINDLE in it.

phillc54 wrote: That is a redundant signal anyway as it is only connected to spindle.0.at-speed and the default is True.

Maybe I should just comment out any line with spindle or SPINDLE in it.

Seems like the prudent approach, as linuxcnc error'd out until I commented that line out.