Plasmac migration problems
01 Sep 2020 06:43 #180260
by Mud
Replied by Mud on topic Plasmac migration problems
That would be great, I'll look for a better float switch
![:) :)](/media/kunena/emoticons/smile.png)
Please Log in or Create an account to join the conversation.
- tommylight
-
- Away
- Moderator
-
Less
More
- Posts: 18337
- Thank you received: 6092
01 Sep 2020 10:12 #180293
by tommylight
Replied by tommylight on topic Plasmac migration problems
Should have just made it 5 or 10 times faster and be done with it.
Thank you very much.
Thank you very much.
Please Log in or Create an account to join the conversation.
03 Sep 2020 00:04 #180477
by phillc54
Replied by phillc54 on topic Plasmac migration problems
I pushed that changed, some info here:
linuxcnc.org/docs/2.8/html/plasma/plasma...r-guide.html#probing
linuxcnc.org/docs/2.8/html/plasma/plasma...r-guide.html#probing
The following user(s) said Thank You: tommylight, Mud
Please Log in or Create an account to join the conversation.
03 Sep 2020 06:32 #180495
by Mud
Replied by Mud on topic Plasmac migration problems
Many thanks ![:) :)](/media/kunena/emoticons/smile.png)
I plan to try the same sensor, but sideways (with some kind of pushrod going up) - I'm not sure if that will change the hysteresis.
![:) :)](/media/kunena/emoticons/smile.png)
I plan to try the same sensor, but sideways (with some kind of pushrod going up) - I'm not sure if that will change the hysteresis.
The following user(s) said Thank You: phillc54
Please Log in or Create an account to join the conversation.
Moderators: snowgoer540
Time to create page: 0.107 seconds