Mazak Micro Slant 15 Retrofit

am I the only one who likes using a 10X jeweler's' loupe?

Thank you for reminding me, about 3 years ago i spent over a week looking for one of those that mount on the table and also have lights, could not find it! Someone told me to look for it at pharmacies, i was so desperate that i did look despite that being wrong advise!
Still do not have one.
We have an online shop that has pretty much everything as they are directly sourcing stuff from Czech republic, but the search function proved useless, have a try
www.gjirafa50.com
In albanian that would be :
lup
zmadhuese
drit pune
thjerrz
-
Good luck !

Wander into a nail salon and ask where they get theirs from?

I assume that Amazon is no good to you either?
I bought this one this summer, I had an older one with a fluorescent tube, but it gets rather hot in use and so I wanted an LED one.
www.amazon.co.uk/gp/product/B086VHPYLS

Amazon does not deliver to Kosovo, and if i choose Albania i get a customs fee of masive proportions!
Give it a try and select Albania see what quote you get.

my1987toyota wrote:

am I the only one who likes using a 10X jeweler's' loupe?
 

Nope.

I have one in my desk at work, one in the mill cart, one in my lathe cart, and a 5x foldable on my keychain.

Plus the usual headband 2.5x and a 4x glasses-type for fiddly wiring jobs.

Does anyone know what cables labeled 53, 364, 55,.... do???
I did figure out the first two, there are at least 60 more with just numbers going all over the machine, almost all of those in enclosed spaces without easy access:)
Got the limits, Z index, spindle everything, the back panel relays ~40 (still have 3 or 4 not accounted for), safety relays, circuit breakers, hydraulic pump and pressure, lube pump pressure, pedals, work lights, tail and its pinion, material forward, chuck close and release, operator panel is fully wired and set in hal and VCP just need two more wires for the hard e-stop, but i have plenty of cables already, etc.
Most of those are still not tested as i have no clue how the hydraulic toolchanger works, what sensors does it use, where are those sensor pins, etc etc