after home it goes past offset toward 0

Start
Prev
1
2
3
Next
End

cncbasher
Offline
Moderator

26 Apr 2016 14:15 #73907 by cncbasher

Replied by cncbasher on topic after home it goes past offset toward 0

make home & home_offset the same i.e 8.0
and as Todd says remove the Typo Alice , you only need one HOME
you probably forgot to hash out one of them , by mistake

Please Log in or Create an account to join the conversation.

Alicee
Topic Author
Offline
Junior Member

26 Apr 2016 14:16 #73908 by Alicee

Replied by Alicee on topic after home it goes past offset toward 0

Mr. Todd,

Wowee yipee ! :-)

I total missed that cause it came from conf program.

Thank you thank you thank you. I go try it again right now !

best regards,
Alice

Please Log in or Create an account to join the conversation.

Start
Prev
1
2
3
Next
End

Time to create page: 0.065 seconds