- Posts: 265
- Thank you received: 40
Retrofitting a 1986 Maho MH400E
- drimaropoylos
- Offline
- Elite Member
-
7 years 4 months ago #135976
by drimaropoylos
Replied by drimaropoylos on topic Retrofitting a 1986 Maho MH400E
Please Log in or Create an account to join the conversation.
- andypugh
- Offline
- Moderator
-
7 years 4 months ago #135977
by andypugh
It's shiny!
(Looking at the picture on the literature it seems likely that the entire shank can be swapped, if modification or pull-stud swap isn't an option)
Replied by andypugh on topic Retrofitting a 1986 Maho MH400E
Glemigobles wrote: You might succeed in selling me on this idea after all
It's shiny!
(Looking at the picture on the literature it seems likely that the entire shank can be swapped, if modification or pull-stud swap isn't an option)
Please Log in or Create an account to join the conversation.
- drimaropoylos
- Offline
- Elite Member
-
7 years 4 months ago #136013
by drimaropoylos
Replied by drimaropoylos on topic Retrofitting a 1986 Maho MH400E
In the Maho speeder the top bearing is located insight the taper, I guess to make is as short as possible. Chances are that the same is happening in this speeder and the taper is not removable.
Please Log in or Create an account to join the conversation.
- Glemigobles
- Offline
- Elite Member
-
- Glemigobles
- Offline
- Elite Member
-
7 years 4 months ago #136018
by Glemigobles
And oh so cheap!
Replied by Glemigobles on topic Retrofitting a 1986 Maho MH400E
andypugh wrote:
Glemigobles wrote: You might succeed in selling me on this idea after all
It's shiny!
And oh so cheap!
Please Log in or Create an account to join the conversation.
- drimaropoylos
- Offline
- Elite Member
-
Time to create page: 2.091 seconds