Mach 3 conversion to Stepconf Wizard

Hello BigJohnT
Would you mind convert my mach3 XML file too, please ?
will use it for a Shapeoko2 and need a xyyz (xyz-y)config

Thanks a lot,
best regards,
cle

[edit] originally attached the XML in a RAR, don't know why it got lost (:
sorry for the inconvenience (:

Hello all,

I've been playing around with an old CharlyRobot with obsolete controllers and drivers. I replace them with Leadshine MX3660 and LinuxCNC but there something wrong with the stepconf I tuned from the datasheet and manuals. Fortunately it comes with a Mach3 xml configuration file, and as I can see I found the right spot to get some help.

Here is the attachement, thanks in advance !
David

I, too, need a conversion from Mach 3 to LinuxCNC. Thank you in advance!

Thanks for all of the support you have given us neophytes for so long. I am taking the acquisition of a newer computer to make the switch to LinuxCNC. Right off the bat, Stepconf wants timing information for my Chinese motor controllers that I don't have. Hopefully that info is buried in this XML file.

Larry

Will you convert mine too? Thanks!

-Cole

Will be extremely grateful if you can convert this one for me please. I don't know where I was going wrong the last time I tried, but just couldn't get it to work.