Linuxcnc - plasma router - joint 2 flolowing error

So, you are all OK now?

Hi, i don't know ..., i must buy the LPT cable (25M<>25F), i have only (25F<>25F) ... ...

i have this board, it is stable ?

There isn't much in them to be unstable.

i have this board, it is stable ?

As Andy has said.

The biggest problem seems to be that people get confused in that it has to have two power sources one being 12-24V for the inputs and spindle control to work and the other is 5V this can be provided from a 5v power supply or 5v from the USB (generally usb's are a bad idea)

Hi all,


i replaced the my bread board to 5-axis chinesse board and moving of all axis works perfect, the Z float switch too. Now i want use PROMA THC .... i set it and now try the test of function of THC. The signals UP/DOWN works in Hal meter ...but the moving of axis Z nothing.

Can you please help me ?

Did you set PlasmaC to Mode 2 ?
Uploading the config folder might help, so on the "config" tab click on "backup" and upload the resulting file.