LinuxCNC + Orange Pi (allwincnc)

Hello, I have such a problem during installation. I don't know how to solve it. I hope you can give me some advice

Thank you very much.

What system do you install on?
Armbian_20.02.1_Orangepione_buster_current_5.4.20_desktop this one is ok

OK, thank you for your answer.、

I'm curious now whether the project has been abandoned or completed.

It is sort of on hold until more Opi boards become available. The original developer archived the project since he could not get new Opi boards in his country due to the worldwide shortages of parts.

I think the project is great. it just needs a good u-boot and preempt_rt kernel for each version of the the Opi's that are available and have the Allwinner ARM SOC's with integrated microcontrollers. If Allwinner stops making them then I'd like to port this project to Rockchip or similar. I'm planing on a Gentoo fork of this project using 64b kernels.

Been following this thread for a while now and been having a play around with a Opi PC, originally I tried a OPi One but that was DOA.

After looking at the OPi schematics I noticed that the majority of the camera connector pins are connected to port E (PE0 - PE15), 2 are connected to port G (PG11 & PG 13) and one to port a (PA17). So that would give an extra 19 pins.

Has anyone tried this yet ?



I've ordered a cable & connector on a breakout board to give it a go, but waiting delivery. Whilst I could probe the pins age is catching up and I don't want to break the SBC.

I got a little sidetracked on my OPi project. Have been using it as I had it set up for the mill but have been playing with my new 3d printer and other projects. I still have intentions of using this with 2 MPG wheels for my lathe. Ordered 2 new MPG wheels to test things out.