LinuxCNC + Orange Pi (allwincnc)

Of course. Sorry.
Long pinheader and at least 1 GB of RAM.

OPi H5 also works!

Wzor, could You elaborate more about H5 support & installation process? What versions of system/LCNC You use?

I found board with H5, that is available now:
linux-sunxi.org/Libre_Computer_Board_ALL-H3-CC
I really like it because it is open hardware / open software design with 2GB of RAM and nice components. I'm thinking about getting one for myself and then prepare drivers/arisc code tailored for me. What do You think abut this board? Any experience?
Thanks,
Michael W.

Libre_Computer did not meet. You can try. Everything is the same as on H3.

www.loverpi.com/products/libre-computer-board-all-h3-cc

It is a bit confusing when you order since the product description is for a H3 but the H5+2GB option has the H5 for $45usd. The H3+1GB option is sold out at $35usd.

www.loverpi.com/products/libre-computer-...ariant=3133794385933

wiki.loverpi.com/sbc:libre-computer-all-h3-cc-h5

wiki.loverpi.com/sbc:libre-computer-all-h3-cc-h3

Amazon $40 www.amazon.com/Libre-Computer-Board-ALL-...ritium/dp/B07D4KTRWR )))