linuxcnc-esp32 Software Stepping over Ethernet Using ESP32

aaronstone
Offline
New Member

2 years 3 months ago - 2 years 3 months ago #304217 by aaronstone

Replied by aaronstone on topic linuxcnc-esp32 Software Stepping over Ethernet Using ESP32

Hi, brother. pippin88
Do you have a problem that you can't find a solution for?

Last edit: 2 years 3 months ago by aaronstone.

Please Log in or Create an account to join the conversation.

mBender
Offline
Premium Member

2 years 3 months ago #305011 by mBender

Replied by mBender on topic linuxcnc-esp32 Software Stepping over Ethernet Using ESP32

Awesome, just saw this topic on the forum. Once the new release is out I will try it.

Please Log in or Create an account to join the conversation.

Bari
Offline
Platinum Member

2 years 2 months ago #307380 by Bari

Replied by Bari on topic linuxcnc-esp32 Software Stepping over Ethernet Using ESP32

Development Board Design Based on ESP32-P4 RISC-V SoC with Ethernet

linuxgizmos.com/olimex-showcases-develom...esp32-p4-risc-v-soc/

The following user(s) said Thank You: tommylight, Mecanix

Please Log in or Create an account to join the conversation.

Mecanix
Offline
Platinum Member

2 years 2 months ago #307390 by Mecanix

Replied by Mecanix on topic linuxcnc-esp32 Software Stepping over Ethernet Using ESP32

Yeah them awesome silicon. Received 2 (two) ESP32-P4NRW32 to prototype hardware with, looking forward integrating them into projects. Here's the pre-release official block diagram for it, the one advertised is kinda old.

CONF. Do NOT share those attachments, yet. For your eyes only.

The following user(s) said Thank You: tommylight

Please Log in or Create an account to join the conversation.

tommylight
Offline
Moderator

2 years 2 weeks ago #312076 by tommylight

Replied by tommylight on topic linuxcnc-esp32 Software Stepping over Ethernet Using ESP32

What is the current state of this as i will be getting some W5500 to play with soon?
More importantly, any long term use results on reliability?
Thank you.

Please Log in or Create an account to join the conversation.

tommylight
Offline
Moderator

2 years 1 week ago #312811 by tommylight

Replied by tommylight on topic linuxcnc-esp32 Software Stepping over Ethernet Using ESP32

Wez's project and discussion moved here
forum.linuxcnc.org/18-computer/51816-esp...en-usb-plug-and-play
He added a lot more functionality and speed !

Please Log in or Create an account to join the conversation.

Time to create page: 0.165 seconds