Remora - ethernet NVEM / EC300 / EC500 cnc board

IP is OK, netmask does not matter but for 10.n.n.n is usually 255.0.0.0 or /8, gateway can be empty or 10.10.10.1 not 11.
Still should work, but seems there is nothing connected to it, so what does
ip a
in a terminal return?

raf1110 wrote:

Got that with this setup
 

Some networks cards do not work correctly if the appropriate firmware is not installed in Linux.
The second problem may be your cable. Do you use network switch or router? If not, you should use crossed cable.
But this is common Linux problem, described in many places in the Internet, not the Linuxcnc or Remora specific.

there 

Not connected to anything, try another cable, directly from PC to the board.
Most new stuff works with any kind of cable, but this might need a "cross" cable, not sure as i never used Remora boards.

Same result
I am suspecting LAN on card is not responding not sure if LED should blink after plugging same as when connected to PC.
Same with rs232 there is nothing in terminal. In video he is showing that after flash and run there is response from rs232 which I didn't found. That made me concerned if I flashed correctly but when uploaded there was no error.(see my previous posts)
Maybe should return and reflash bin file and restart from there?

Ok, maybe work through this one step at a time.

1. First ensure that your RS232 adaptor is working correctly. Loop TX to RX and confirm you get a reply when you send something from Realterm or which ever terminal you are using. Setting is 8N1 115200 baud

2. Connect your RS232 adaptor. TX -> RX and RX -> TX

3. Flash the board and confirm debug serial output

4. Move on to Ethernet connection, no special cable needed for direct connection to the PC