Axis configuration not fully working on 2.9.6

For the Pi5 users:
www.linuxcnc.org/temp/linuxcnc-uspace_2.9.7pre_arm64.deb

Hey guys,
I just now had the time to install the new .deb file and try things out.
All my problems are fixed now. The pendant and MDI commands work as intended again.
Thank you all for your help!

Thank you guys for the quick fix...  

cheers miniwini

Andy, if this is tested as working, can you build an official 2.9.7 release and put it on our repo for bookworm and Trixie?
temp folder does not sound very permanent image missing /media/kunena/emoticons/shocked.png

2.7 ?
You mean 2.9.7 most probably.

rodw wrote:

Andy, if this is tested as working, can you build an official 2.9.7 release and put it on our repo for bookworm and Trixie?
temp folder does not sound very permanent image missing /media/kunena/emoticons/shocked.png

I plan on doing so, but I will have to build all the variants by hand on a selection of VMs and RPis as Buildbot2 seems to be broken. It stalls at the end of the RIP builds:  buildbot2.highlab.com/buildbot/#/grid
00-checkin has been running for 1 day and 15 hours at the moment, the previous two builds were killed by me from the IRC interface after similar times stalled.