Machine controls greyed out

The pc is a Dell optiplex 7010 can anyone name a parallel card that is known t5to work with linuxcnc

Paul

Does 7010 have PCI or only PCI-E slots?
For PCI ones, i had several types, all of them used MosChip/NetMos chipsets and all of them worked (and still are working) with LinuxCNC.
No PCI-E so far, mainly couse i could not find them here.

It has both slots the not working port was in PCI-E . I'd sure appreciate a list od PCI cards. Amazon could have one here Mon

Paul

tommylight

Do you hve a pci card for me?

thanks
Paul

Yes, but the shipping will cost me 65 Euro !!!
I am in Kosovo, our postal service was bought by Deutche Post a while back, they gave up and just plain left it, bikes and cars and vans also!
The only thing that works properly in that regard is DHL, post office is hit-and-miss with receiving stuff and just refuse to ship anything abroad from here.

If I was looking on Amazon then I would probably try:
www.amazon.co.uk/Controller-IEEE1284-Par...ATIBLE/dp/B0010V7K8S

Avoid any where the main chip is small and low down, those tend to be using a general purpose chip that needs a driver at boot-time to become a parallel port. And the driver is Windows-only.

Or: Get a 5i25 which is better than a Parallel port card, and will definitely work.