LinuxCNC 2.9 RPi - PNCconf error

phillc54 wrote:

While waiting for my RPI to update I ran PNCconf to the end and noticed this error if I selected a 7i96s:

Warning: Spoiler!

 

I don't see that if I select a 7i96.
 

Looks like an off by one error. I'm just not sure if the firmware data is wrong, or the parsing function is wrong. I would need to have the firmware output from mesaflash to test with.
I'll change it so at least it doesn't crash. Thanks.
 

It worked!

And I wish I would've read the note after ./configure to run "sudo make install" instead of building the package!

Excellent. thanks for the feedback.

I could only see 8 in this attachment

 
 

Ok great!

When I try to reopen the .conf file, I get the attached error. I did use custom HMID on the INPUT page of help. Terminal shows: **** INFO firmware 0 changed. Do you think that's the cause?