Gscreen - a GTK / Glade / Python based screen

I can't wait to get out to the shop and try this... way to go Chris!

John

Looks very nice! Where is it located? (git repo?)

look a few messages back Dan , and install against emc2-dev git repro , then rebuild
shout if your stuck

Dave

it's in git repo of my private computer.
If it proves worthwhile and functional I will incorporate in linuxcnc.
right now still experimenting, though it will run a standard machine.

Chris M

I warn you - its still being developed and tested please test in a simulated config.
there are a couple hidden features that could move the machine unexpectedly.

cncbasher

re. machine-on button.

Is this functionality needed? I could not think of a need to have the machine out of estop but machine off, so I combined them.
It's easy to have them separate if there is a good reason.

Ah ok - it's in the patch file. I missed that earlier.