Linuxcnc always wants to update my INI file

tommylight wrote: I have not yet done much testing on 2.9, but 2.8 requires that to be 1.1
Anything else and it will try to run the wizard to change the version.

Thanks, Tommy. 1.1 works in 2.9, too. I had 1.1, at some point it complained, but now it's not complaining.

You are welcomed.

It's a good practice to use the documents for the branch your using.

linuxcnc.org/docs/2.8/html/config/ini-config.html#_emc_section

JT

I'm using 2.9, and those docs say "It’s a good idea to change this number each time you revise your file."

The 2.8 and 2.9 docs say:

You might need to refresh your browser with Ctrl Shift r

JT

hello
i changed my ini file because i want to use probe screen v2 with gmoccappy. now i always get a message at linuxcnc start (picture) i have been using v2.8 for a while without any problems and the update that he suggests doesn't work. if I click no then everything goes on normally. what am I doing wrong here?