Linuxcnc 2.9.2 and 2.93 images for Raspberry Pi 4b & 5

You should be able to set up auto login the same way it is done with an x86 machine as its the OS you are logging into

Hi,
The Linuxcnc 2.9.2 and 2.93 images for Raspberry Pi 4b & 5 are
special OS. The menu-config configuration does not have the option for auto login.

JAMSys wrote:

Hi,
The Linuxcnc 2.9.2 and 2.93 images for Raspberry Pi 4b & 5 are
special OS. The menu-config configuration does not have the option for auto login.

Nothing to do with menu-config. Its all Linux
gnipsel.com/linuxcnc/debian-11-fix.html

JAMSys wrote:

Hi,
The Linuxcnc 2.9.2 and 2.93 images for Raspberry Pi 4b & 5 are
special OS. The menu-config configuration does not have the option for auto login.
 

Rod's the one that has put them together, apart from the RT kernel & the addition of the Linuxcnc packages it's just Debian. Nothing special about the actual OS.

Thanks a lot. This is the info I was looking for.

hi, can this image use traight to gpio too, rp4b board and i made 3,3V to 5V output level converter board use traight gpio output to stepper motor drivers DM556,
and same i build optocouplr board all input opto to gpio can use safety all gpo, not used BOB card or other board, i made diy own in/out gpio to 5V convert board, hope image can use straight all step/dir, enable, signal out to gpio pin. its easy use level converter module can convert 3,3 rpi output to 5V input by stepper driver controller etc, DM556.
same i think can easy use optocoupler module all input gpio pins. 5-24V in to opto and then 3,3V safety to in rpi gpio.