Advanced Search

Just looking at homing.c source and it has a reminder in a comment.
                   // docs: 'If HOME_SEQUENCE is not specified then this joint
                   //        will not be homed by the HOME ALL sequence'
Do you have a home_sequence set for all joints?

 

Much respect for the traditional way but I would like to come up with a 21'st century option. Digitizing from the image sounds good. I'll look into it.

Thanks,
Tom

I can confirm that it misbehaves if I change my location to SK.

I will look into it further.
 

I had this happen recently and what I discovered is that I had previously removed some packages at the OS level. APT indicated they were no longer used, so I removed them against good judgement.

Once I re-installed them my pendant started working properly.

Thank you it was a fault reply but nice info. I am also thinking about getting some other scales. I think its much faster and a lot more streamlined for my retrofit.

I’d look for a CAD package that lets you import an image and “trace” it. Bear in mind that the time it takes you to do that it maybe just as quick to cut the various members the traditional way.

Hi Beovoxo. If this message was meant for me... I've bought 2 Exe 601, but don't need themnanymore.
I bought new 1um cales with differential RS422 signals.

If you need the Heidenhain 601 converters, the are available.
Kind regards, Jos

cmorley, that screen looks very good! Would you share this with me? How can i install it, I am running that normal QTDragon for a while and was missing some of the buttons integrated here.
Thanks in advance!

I have my Lichuan LC10E drive and servo successfully doing internal homing, but I can't figure out how to make the Axis "Home All" button trigger it.  Setting x-home-request signal in halshow generates a homing cycle, but Axis "Home All" causes the motor to just spin quite independently of the drive homing parameters, and never completes.  The x-home-request home cycle completes, and turns on x-homed (cia402.0.stat-homed and joint-0.cia402-homing-finished), but this is also not reflected in Axis.Where does this alternate homing process get linked into Axis?  I have been trying to trace it from halui.home_all but get lost in the bowels of emc.Thanks,-- Ralph

Hey Bari do you have any pictures of it or so, plans. I was thinking about doing the same for my build.

Thanks,

Hi all. I think I have issues with how the paths are defined in my INI file. As for as I can tell they all point to the correct folder but perhaps not. I think the errors saying "pycall(remap.change_prolog) failed" reflect this but I am quite possible wrong. Can anyone see the problem?
I copied the nc files from the examples folder up a level. Should I go back to changing the path to /home/luke/linuxcnc/nc_files/examples/ ? 
Thanks
Luke 

Thanks for the hint, already did that but haven't updated repo yet.

I noticed that following joint error happens a lot when moving with encoder wheel on nvmpg even that gcode results in much higher speeds. For now I limited jog speed to 40mm/s.

Hello,i've followed this  thread and i've got the CCAT driver installed so far, but i was realy confused i've got so many warning while compailtion, so what...
The question is how do i mount or assgin the

Beckhoff pci ethcatmaster{(08:00.0 Unassigned class [ff00]: Beckhoff GmbH Device 5000 (rev 0)) => which seem is the interface for the onboard KL-modul of the plc/ipc }

as master device to the ethercat stack?
i add a copy of my terminal log

the actual master you see is an Beckhoff CX2500 module and runs good so far.

might anyone has an idea

kind regards,
Christoph

zelo, make your stepgen maxaccel higher than your regular max accel