Pimping the mini-lathe

More
6 years 2 months ago #177931 by RotarySMP
Replied by RotarySMP on topic Pimping the mini-lathe
Regarding using e as EXP [n] or EXP(n)

I tried to set the spindle value with
S EXP[n]
S [exp[n]]
S [EXP(n)]


but all combinations return "unknown bracket missing after unary operation

Please Log in or Create an account to join the conversation.

More
6 years 2 months ago #177933 by tommylight
Replied by tommylight on topic Pimping the mini-lathe
Regarding spindle, have a read through this, some nice pointers there:
forum.linuxcnc.org/38-general-linuxcnc-q...-0-10v-analog#177085

Please Log in or Create an account to join the conversation.

More
6 years 2 months ago #177934 by PCW
Replied by PCW on topic Pimping the mini-lathe
Typo:

net spindle-ccw <= spindle.0.reverse
net spindle-cww => hm2_7i96.0.ssr.00.out-02

The following user(s) said Thank You: RotarySMP

Please Log in or Create an account to join the conversation.

More
6 years 2 months ago #177936 by RotarySMP
Replied by RotarySMP on topic Pimping the mini-lathe
I'm the worst coder. and an even worse proof reader. Thanks for spotting that PCW.

Thanks for the link Tommy, I'll check that out.
Mark
The following user(s) said Thank You: tommylight

Please Log in or Create an account to join the conversation.

More
6 years 2 months ago #177940 by tommylight
Replied by tommylight on topic Pimping the mini-lathe
Last video was very nice, thank you.
The following user(s) said Thank You: RotarySMP

Please Log in or Create an account to join the conversation.

More
6 years 2 months ago #178378 by RotarySMP
Replied by RotarySMP on topic Pimping the mini-lathe
Episode 27 is up...


Enjoy.
Mark

Please Log in or Create an account to join the conversation.

Moderators: piasdom
Time to create page: 0.164 seconds
Powered by Kunena Forum