Linuxcnc plasma rotary
02 Dec 2020 13:04 #190872
by andypugh
Replied by andypugh on topic Linuxcnc plasma rotary
Your geometry might be assuming that the shape is below the centreline.
I think that the rotation radius maybe should be negative (bigger radius = smaller Z height)
I have a similar problem with my manual-B 5 axis setup.
I think that the rotation radius maybe should be negative (bigger radius = smaller Z height)
I have a similar problem with my manual-B 5 axis setup.
Please Log in or Create an account to join the conversation.
- marcolagares
- Offline
- New Member
-
Less
More
- Posts: 2
- Thank you received: 0
02 Dec 2020 14:31 #190875
by marcolagares
Replied by marcolagares on topic Linuxcnc plasma rotary
Hi Andy
Glad to talk with a master.
About center point, in the machine i am setting 0 @ center chuck.
In sheetcam i need to put positive otherwise it set wrong the working space.
Thank´s in advance.
Glad to talk with a master.
About center point, in the machine i am setting 0 @ center chuck.
In sheetcam i need to put positive otherwise it set wrong the working space.
Thank´s in advance.
Please Log in or Create an account to join the conversation.
31 Jan 2024 03:40 #292040
by JeffreySc
Replied by JeffreySc on topic Linuxcnc plasma rotary
Is there a post processor for standard Plasma table with out rotary? I have Sheetcam and a Commandcnc controller. I would like to use fusion 360 instead of Sheetcam if possible. Thanks
Please Log in or Create an account to join the conversation.
- snowgoer540
-
- Offline
- Moderator
-
Less
More
- Posts: 2388
- Thank you received: 779
31 Jan 2024 12:35 #292062
by snowgoer540
Please Log in or Create an account to join the conversation.
Moderators: Skullworks
Time to create page: 0.091 seconds