Probe Basic probing without Z-Axis?

......ah,ok!
That's not done in 5min

I changed almost everything in my current system (linux & linuxcnc), maybe a new "clean install" is a good idea....
I read the latency also improved with Debian 12 & 2.9, that's a fine thing too....

Thanks Chris, i will write back when i finished the upgrade - but maybe takes some time

Martin

These instructions of mine should let you get Bookworm  up  with minimum fuss
docs.google.com/document/d/1jeV_4VKzVmOI...diY/edit?usp=sharing

Thanks rodw, that worked fine....
A Probe Basic Sim is also running fine.
I installed it on an old HDD for testing, so i can run my machine just changing to SSD....
Now i have to import my ini & hal etc.....

Martin

Hello,

had no time to play the last weeks, sorry!

i have an issue...

1. probe basic sim is running
2. example machine is running in axis
3. but when i want to start probe basic with my ini i have got an error:
can`t execute display programm

.....i was not able to fix that - any idea?

I'm so happy, i have installed it on an old HDD

Martin

You need to perform the conversion for your config.  Conversion doc linked below:

forum.linuxcnc.org/qtpyvcp/48401-configu...-for-probe-basic-py3

Hello,
...i did that several times, also created a new machine just to test - no luck!

But now i have a funny question:
...is it possible, that the new system don't work with a "StepConf" created machine?

Martin