Hurco KMB-IS CNC update

@sasiprapha
No double posting.
Leaving both till someone replies, then deleting the one with no reply.

Hi,

I believe those are 3hp but will have to check. I have a manual somewhere, but time is the problem for me.

I have 2 of the KMB-1 models and those came with 2 options a 3 and 5hp motor. Both of mine are 5hp motors.

I will try and look it up tonight to get you some info, just too busy at moment. I know i have a manual here somewhere.

Thanks,
Robert

tommylight wrote:

@sasiprapha
No double posting.
Leaving both till someone replies, then deleting the one with no reply.

The other topic with no reply has been deleted.
Thank you.

From my KM3 and KM3P
MotoMex Somex
ST-37A
1800 rpm 3 phase
230 V, 8.5A
460 V, 4.25A
possible part no 694729

Thank you very much

ALL of the hurco km3 and km3+ mills that I have seen are 3hp, the Hawk which is a slightly upgraded version of the km3 with 2 more inches of z travel, that unit has a 5hp motor and a bigger bed as well as boxed ways, but that may not be ALL of the many variants. One thing I think you could do, is find a hawk head casting, and swap the km3, They looked close last time I took measurements. 

As to the Electrokraft brush motor drives, 

Here is that manual 
drive.google.com/file/d/1jE7EJiprhJXXgmJ...sDg/view?usp=sharing