Hurco KMB-IS CNC update

_big_ wrote: As a matter of course, did an apt-get update, apt-get upgrade, and now she won't boot.

apt-get dist-upgrade

Thanks Tom, will have to remember that myself even...

Seen that at least 20 times in the last week alone, always regarding RPI4 and always issues after running upgrade, but i do not have a RPI4 so i have no way of checking and kept my mouth/fingers shut.
On machine PC's i never use upgrade, only dist-upgrade.

Ok will remember that. I bought my Dad a Pi3 years ago for a little project he talked about, will have to tinker with it. Just never have had time to check it out, but been wanting to see how it does with LCNC though.

You might be able to get the Pi to boot again by mounting the boot volume in a different machine and adding this line to the config.txt file.

total_mem=3072

If that doesn't work:
I made a new Pi SD card image that (on my test Pi's) does not have this problem.
I would appreciate if you could try it and report back.

www.linuxcnc.org/temp/image_2021-01-20-linuxcnc-pi4-3G.zip

Andy,

If Leith doesn't try out your SD image and get back with you, then I will check it out when I get some free time. I've gotten busy again, but holidays are over and hopefully can get some some of these projects finished. As always, thanks for all that you guy's do for us.

Thanks,
Robert