Deckel Retrofit FP4A

Even more curiously my machine casting says 2810 Everywhere. on the spindle casting the main casting etc.

The sheet metal housing says 2821
And the electrical cabinet says 2821 aswell..

what the hell did i buy here..

which control was this`?

It was a Dialog 4 in a Contour 3 Housing (Replaced st some point)

I am never gonna be this stupid again and buy a machine with an electrical cabinet that does not fit together :woohoo:
i noticed a small small amount of mismatch in the pin occupation of the X Connectors so i am gonna and will have to redo the entire electrical cabinet from Scratch... god this will take long

I am just gonna replace a lot now. Starting with an VFD

i am only have them for tnc355, dialog 11 and contour4.

VFD? check the typlate of the spindle motor. if it is vfd capable.....

It is. Others have done so before too as far as i know. thanks for helping