Potential All-in-One Single Board Computers

Now i have bought bei ebay a 980 i5 for 50 bucks - i give it a try.

@Bari,
The thread is for 'potential' computers.
How/where do we record the yeah/nay of if the potential bears out?
@rodw gave good reason why the Odroid N2+ isn't a good choice.
I can testify that the OPi5 is a good choice.

Start a new thread about your project. Link to it from here.

Or add to this one if it's about the Opi5:

forum.linuxcnc.org/18-computer/48079-can...e-configured-to-run-
lcnc

The last post on that thread it mine.

It's a picture of the results of an OPi5 using LinuxCNC to drive a Bridgeport mill. So. . .yeah. The data is being captured.

@rodw Have you tried the kernel I had compiled for the s9xx? It seems like it uses the same kernel config for the s922x:
github.com/ophub/amlogic-s9xxx-armbian/


mega.nz/folder/qshRQAbR#0p25gwbiAXH41v2ZB6fZMg

UP-7000 Intel sbc with 40 pins header via Intel® FPGA Altera Max V

up-board.org/up-7000/