Mesa 7i95

Hi,
can you point me in the right direction how to control VFD with 7i95 board?
The vfd inputs: voltage 0-10v, frequency 0-100KHz and rs485

thank you

0 to 100 KHz could be generated by a Stepgen if one is free
What signal levels are needed for the 0 to 100KHz signal?

Hi,
thanks for reply. It requires 9-30v

Take a look at this thread:

forum.linuxcnc.org/38-general-linuxcnc-q...onnect-7i96-to-a-vfd

Thanks, I was thinking simple mosfet level shift but I think I will go for opto just for extra safety.

One more question where do I find the latest bit file/ source files for the 7i95? is the latest on your website or somewhere on Git?
(I am sure it has been answered milion times but I am useless at finding the answer.)
thank you

Any FPGA card zip file will have the sources for all FPGA cards