New project, litehm2: a hostmot2 port to linsn rv901t

How did you manage to do this ?

sensille wrote:

Thanks, but does not work.
The LED blinks, but no responds to ping and network connection are unstable (disconnects and connects again...).
I have this same when compiled myself.
In my opinion (but I'm not sure), the Spartan has to few resources and some gates are shared to different modules (I suspect this from some warning messages).
I have got two RV901T, one can use with JTAG (Xilinx Platform Cable USB, both with flash programmer (EZP2023+).
I not see difference which programmer is used.
I tested my RV901T with Litex-CNC project, and only very small configurations work. More complex projects are compiled without errors, but are unstable, or work not properly...
In your project there are other problems, but the reason may be the same...
 

No, it is rock solid for me, and I don't think your configuration is too large. 88% LUTs is a bit on the heavier side, but all timing constraints are met. I will program the bitstream and see if it works for me and if it the connection is stable.
What do you mean by unstable exactly? How can I reproduce it? I really want to get it working in your setup

Oh, another question ... In the beginning I had problems with stability because my power supply was not good enough. To be more precise, I just used chinese dupont-style jumper wires, which barely have any copper in them. Can you check that your supply really is stable?
About the importance of having a back-to-back ethernet connection we already talked about.

I usually use
mesaflash --addr 10.10.10.10 --device ether --write xxxxxxxx.bit --fix-boot-block
After that, ping 10.10.10.10 can be normal

@tuxcnc the bitstream is now running here on my unmodified board for nearly a day without an "error finishing read" message. I'm pretty sure you have a different problem with your hardware, not with the bitstream.

(I changed the driver direction to output though to prevent the fpga from getting too hot)