(superseeded) Linuxcnc on Linux Mint 19.3 quick and easy installation

Did you check the last post on the Debian thread?
I use Mint for a single reason, the most important one, IT WORKS ! Always, with everything i have, and i do have plenty (beginning to think i am a very bad hoarder of technology).
And i do understand everything you say, but this is a community of people and there will always be such minor issues, but we have to help as much as we can. And as for communities, i have spent quite some time on the net since ..... over 20 years, and i can say this here is the best by far. Case in point, i was on cncecke.de a lot and almost all users there are great, but there is always one that wants to show off so he found a silly reason ( me writing in English and German everything ) and went off the handle.
Just checked there, my reply to him is not there while everything else is !
Cnczone.com was quite nice, mostly, but i have not been anywhere else for a long time. I mean forums.
There is no place like 127.0.0.1 !

Nate wrote:

do you have a youtube video showing the steps of this if not would you mind making one

What step are you having trouble with ?

You did not hold down CTRL+Shift when booting the computer.

OK