Linuxcnc & the Raspberry Pi (4 & 5) Official Images Only!!!

I have installed the PI5 image (25-01-27) and have gotten everything working EXCEPT the hal_gpio input pins. Outputs...done, inputs... no luck. I can read the input pins with GPIO from python... but not within linuxcnc.

Any ideas?

Read through this thread, there is an example in this very thread.

There is also an index to this thread located here.
forum.linuxcnc.org/38-general-linuxcnc-q...official-images-only

hi, i installed linuxcnc raspberry5 4gb image on ssd and it starts normally but i am not able to connect to wifi. i followed the instructions, used menuconfig with my data and country=IT but nothing. maybe because in the ssid there are two spaces? "FRITZ.Box 7590 BX" i tried before asking... god knows how much i tried

I installed network manager and both connections, 7i80 and internet are fine.

That's the easiest way, I think I mentioned that earlier, I like Network Manager as I can turn the wifi off whilst running a job.