Advanced Search

Could you open halmeter from a terminal and select the pin plasmac.feed-reduction and then do another video. It should change to 60 as it begins each fillet end return to 0 at the end of each fillet.
 

I made a mistake by adding gtktooglebutton instead of hal_toogle, thank you very much.

Not sure what you are doing:

 

 

 

I have attached a short video made with PEEK which shows the velocity increase at the last leg of the contour. Maybe this gives a bit more insight in the issue we're facing.

Cheers, Peter

Normal buttons were created, but I copied these buttons from the 6 button examples. That's probably why it works. I think the reason why the toggle buttons are not visible is that I cannot add it to the configuration line you mentioned.
Secondly, I can change the ramps and limits from the gui, but no matter what I did, I could not change the calibration value.
There's probably something wrong somewhere
example:
testpanel3.hal:
net xvl ini.xmax_accelaration <=  testpanel3.hal_xacc-f it's work
net xmul cia402.0.pos-scale <= testpanel3.hal_xmul-f it's doesn't work
net cia402.0.pos-scale <= testpanel3.hal_xmul-f it's doesn't work
setp cia402.0.pos-scale testpanel3.hal_xmul-f it's doesn't work
sets cia402.0.pos-scale testpanel3.hal_xmul-f it's doesn't work

Wenn's immernoch nicht läuft bitte die aktuelle config zippen und posten.

I don't have a problem with raising awareness about safety, there are a few post of mine on this forum where I have suggested safer procedures than what was being used. The statement I do not agree with is this one:

Linuxcnc ‘gate keepers’ should warn users that - software estops are not allowed - for safety sake.

It's enough of a struggle to try and keep the existing code base and its documentation even halfway updated with the volunteers we have. If you would like to add information about safety then I would invite you to add to the wiki:
wiki.linuxcnc.org/cgi-bin/wiki.pl

Thank you Phil, I will have a deeper look here too.

try this script
forum.linuxcnc.org/ethercat/45336-etherc...tep?start=250#307276

No worries, this is distracting us from your main issue anyway. 
I really don’t know what is going on with the velocity as it works fine here. I will have a play in the morning and see if anything odd happens. 

hallo,

die sind alle in der .ini..

karlhe

 

No success Phil, I still get the M190 related error, see screenshot attached. I must admit I have never used sim configurations, so this is out of my depth

My bad...

Need to remove the ~ from the beginning of the second line:

 I am using your recent image only but i con't able to intall ethercat -master following this

Hi Phil,

I get this :

plasma@plasma:~$ mkdir -p ~/linuxcnc/nc_files/m_files
plasma@plasma:~$ cp ~/usr/share/doc/linuxcnc/examples/nc_files/plasmac/m_files/* ~/linuxcnc/nc_files/m_files/
cp: cannot stat '/home/plasma/usr/share/doc/linuxcnc/examples/nc_files/plasmac/m_files/*': No such file or directory

This is out of my territory I am afraid