Gmoccapy Bug?

newbynobi wrote: We are at -9 degree celsius?

Minus 13 C here, last night went to -22.
I miss the sun..........who was complaining about to hot????? Wana trade?

Norbert

Were are you?
It was 0 Celsius this morning here in Orem Utah and its warm today.

In the North of Germany, near Hannover

Norbert

thor44 wrote: I also have a similar problem. I can pause the machine but if I stop the machine in mid program the machine will skip(move) to a new line sometimes several hundred lines down in the program and then stop.

How do I get gmoccapy 2.2.2? and how do I install it?

From source:

linuxcnc.org/docs/devel/html/code/building-linuxcnc.html

or use buildbot.

Norbert

tommylight wrote:

newbynobi wrote: We are at -9 degree celsius?

Minus 13 C here, last night went to -22.
I miss the sun..........who was complaining about to hot????? Wana trade?

Me, complaining about our impending heatwave week... today 36C, tomorrow 37C, Wed 40C, Thursday 37C, Friday 42C

If it was possible to trade I would do so in a flash, love cold, HATE heat.

This is 50km north west of Sydney, Australia

racedirector wrote:

tommylight wrote:

newbynobi wrote: We are at -9 degree celsius?

Minus 13 C here, last night went to -22.
I miss the sun..........who was complaining about to hot????? Wana trade?

Me, complaining about our impending heatwave week... today 36C, tomorrow 37C, Wed 40C, Thursday 37C, Friday 42C

If it was possible to trade I would do so in a flash, love cold, HATE heat.

This is 50km north west of Sydney, Australia

And me, Another 1000 km further north and closer to the equator in Brisbane Australia.