Hypersensing questions

Deleted

Above post deleted due to some new information, will report back after sifting through it.

tommylight wrote: Above post deleted due to some new information, will report back after sifting through it.

Well i guess i can put the 4 resistors away then? :laugh:

Patiently waiting in suspense...

snowgoer540 wrote:

tommylight wrote: Above post deleted due to some new information, will report back after sifting through it.

Well i guess i can put the 4 resistors away then? :laugh:

Patiently waiting in suspense...

Haha I had mine out as well! Eager to try anything, but don't want to ruin anything

snowgoer540 wrote:

tommylight wrote: Above post deleted due to some new information, will report back after sifting through it.

Well i guess i can put the 4 resistors away then? :laugh:

Patiently waiting in suspense...

As i mentioned before somewhere, i have 4 o the THCAD on the way to me, so i can not test anything for now, but PCW reminded me that the ohmic sensing is not disconnected after probing, and that is a bit of a doodle as it can catch the wrath of the HV/HF start from the plasma and cause all kinds of havoc.
For now i have to wait, and even when i get them i have to find a plasma cutter with a shielded nozzle, all i have use no shields for that.
Then again, those THCAD can withstand quite a lot, so thinking differently for now.

So I think we need to explore what can be done in software before we give up. It would be good if Uthayne could disable the encoder filter and see if the voltage difference between on and off increase or not as I have never had it enabled.