Raspberry Pi 4 with PlasmaC

Then mode 0 it is.

Is there a Summary / Sticky or update to this thread of best way to get Plasmac going on Rpi4?

2.8 is in the midst of being released so there will be an iso image available.

There is a pre-release version available here:
www.linuxcnc.org/iso/linuxcnc-2.8.0-pre3-pi4.zip

Perfect.....thankyou

FWIW, I've seen much better performance when running from USB drive as opposed to uSD. Many have used a USB->SSD adapter and use larger SSD drives and again because of USB they get good performance.

I looked at the first 2 pages and last 4 pages and saw no mention of QtPyVCP so I was wondering if you did any development on your touchscreen interface?

I have linuxCNC running on an rPi4 controlling a 3D printer via Scott Alfords Remora(spiPRU) and want to get rid of the monitor/keyboard/mouse and go with a 7" or 8" rPI touchscreen. But when I tried to bring up a sample VCP using editvcp it crapped out wanting some x86 stuff. So I was wondering if/how you were building your display?

Update: I got editvcp working on the rPi. forum.linuxcnc.org/qtpyvcp/38242-qtpyvcp-documents#203469