Mazak Micro Slant 15 Retrofit

I read your servo fine tuning write up, nice, really helped my fine tune my machine, up to 160 ipm now !!

smc.collins wrote:

I read your servo fine tuning write up, nice, really helped my fine tune my machine, up to 160 ipm now !!

Nice, glad it helped.

I posted my latest configs, still fighting my stuff, check my thread if you want. again thanks for the info you've shared, it's appreciated

I already had a look at the first ones, but since i have yet to use "carousel" component, it is still a bit misty to me also.
Unfortunately, due to time restraints i am not sure when i will have the chance to give it a go.
I might just start building a new two-sided-4-or-5-axis-each-side machine for welding some metal framing, despite my insisting on just buying one, i was told by them that there is no such thing ready made. Some research is in order...

wouldn't it be easier to just buy a robotic arm ? they've gotten really cheap "relatively speaking" and they are much better suited to tasks like welding where your have a lot of complex wrist, forearm, shoulder movement.I know, i weld, and out of position stuff is difficult.

i know a few places in Detroit selling older automation arms if you want one. shipping will be a beast but i can put you in contact with my  machine broker, if it's out there, he can find it.

They had a Kuka KR150 i installed and wired and programed several years back, they sold it.
Thank you for the offer, but i am in Kosovo, getting a Mesa board here is a chalenge, getting a truck full of amonium nitrate is very easy.