Mazak Micro Slant 15 Retrofit

Yes, it is expensive to change those motors if they can be solved with encoders on the 7i77, if the amplifiers already have an analog input. here the servo motors of that power are Chinese with a driver around 500e.
if you already work on machines, you should leave one good lathe for yourself, this one looks good

Nice one Tommy, to get a beast like that under LinuxCNC control. You are a master!
Mark

can you post your configuration file ? I'd like to see your tool changer arrangement, sounds similar to my cincinnati

smc.collins wrote:

can you post your configuration file ? I'd like to see your tool changer arrangement, sounds similar to my cincinnati

Of course.

mislim da se najbolje uci iz tudjih primera koji rade, evo ja gledam ove tvoje i uz malo predznanja, pomalo i uhvatim neku foru:) inace kako ide, jel blizu da sve radi?

Ma nije, sad mi nije vazno vise, za drajvove me nije briga, imam jos 4 manja DC servo drajva koje mogu da koristim. Zadnjih dana radim neke druge stvari, pa kad budem mogao pokusacu da nadjem koje zice sta rade za postojece drajvove, sanse su da je jedan propao posle prvog napada miseva, to sam video na ekranu kad sam poslednji put ukljucio masinu pre godinu ili vise dana.