Touch panel question
07 Jun 2018 13:52 #111879
by tecno
Replied by tecno on topic Touch panel question
Yes wires are swapped due to my installation = mill X inverted lathe Y inverted.
Poking around in my lathe but not getting any closer there yet still away a bit from touchpoint to cursor.
Poking around in my lathe but not getting any closer there yet still away a bit from touchpoint to cursor.
Please Log in or Create an account to join the conversation.
07 Jun 2018 14:28 #111884
by tecno
Replied by tecno on topic Touch panel question
Now I am also satisfied with my lathe and touch.
Once again BIG THANKS for the support from this community this is very much appreciated.
Once again BIG THANKS for the support from this community this is very much appreciated.
Please Log in or Create an account to join the conversation.
Time to create page: 0.190 seconds