Need help to install 5 axis knematics

@REX299
Please upload the pictures here on this forum, using third party sharing sites is never a good idea.
Thank you.

Your mean copy to "Sim. Axis.vismach.." Folder? Cuzz I don't see any new installation folder after upgrade to 2.9
Sorry for some stupid question like that

P/s I just success modified C axis in-out pin on .hal and .ini file on v2.8, not done with kinematics setup.

@tommylight
Thank you for recomandation. Sorry about that

Your mean copy to "Sim. Axis.vismach.." Folder?

No don't do that.

But since you wrote this in your first post:

I builded a mini 5 axis mill XYZAC, I had success modified HAL and INI file for my machine on Linux v2.8.

I got the impression that you already have created a configuration (HAL and INI file) to get your machine running under Linuxcnc 2.8.
Is that not the case?

I just created my configuration via stepconfig wizard then modify number of axis, joint, in-out pin in hal and ini file to match my physic connection. I can run Linux with my configuration file, no error. With me that's a big success 

So then you copy the folder that contains the hal and ini files of your machine over into the linuxcnc/configs folder of your new 2.9pre installation and you should be able to start it there too.
Then you can start to look what you need to add to it get what you want.

[edit]
I don't think we are on the same page anymore.
Do you now have a running configuration of your 5-axis machine on the new 2.9pre installation?