Lathe Macros

Thanks that did the trick.

I power read through the entire 44 pages of this thread and made some notes along the way.

IIRC somewhere buried on one of those pages was a link to an excellent video demonstrating most if not all of the lathe macros.  I think the first segment was facing and then a minute or two for each macro feature .

Does anyone know where this video is hiding?

Much appreciated.

 

This is the only one i could find that resembles what you describe, but no GUI is visible, just lathe doing it's thing

I had the link for that one. Perhaps I wandered off this thread when I found it. It was a compilation of I think all of the macros showing the actual operation on a lathe much like the video you referenced, just for all the different operations quite a good video, no idea where I found it and can't seem to find it.

Thanks

Yeah, i wasted 20 minutes last night looking for it, but all i could find was some very short videos of it, so either my serach-foo is failing me or google has gone completely off the rails. I am rooting for the latter:)

Perhaps it's my imagination but it seems like Google in the past was better at searching out general information, lately it seems to favour merchandise over information.