Advanced Search

I’ve been trying to get some stuff working and it’s starting to get there, 

 Added some stuff and mpgs are reading and moving X, Y, Z but it immediately throws an error of positioning error, tired to adjust max acceleration for all axis, and also asked AI to help me make filtering/limiting, worked a little bit, but it went slow and unresponsive,

picture explains more of what happened 

sorry for all comments in the files being Swedish.

@Pipik and @SebastianM
No double posting please.

i dont do it over a wizard.. only by hand... in the hal and ini.

The issue with the error is being dealt with:
github.com/LinuxCNC/linuxcnc/issues/3510

Andy, did you delete your post?

9V is 90% of 10V, makes me think in the wizard the default values are 10%-90%, but not sure if on StepConf or PncConf.
Check the hal if that is the case, namely if the max PWM value is 90%.

Hi guys.
i am a little bit confused.
I get from amazon a pwm to 0-10v converter.
I try it out first on a arduino which has 5v outputs on the GPIOs. works fine.

then i switched to my 7i92 and 7i92t!
i reach only 9v -9.04v if i screw in the calibration cap.
In the hal i set different pwm base freq. from 1khz up to 30khz. nothing helps.

then i come to the point that the optocoupler on the converter isolate the circuit. this means for me it doesnt matter which voltage is coming from the mesa right?

what are the cause?
i dont search for circuit diagramms..

the idea what i have was to take a lm358 and make it on a breadboard..

but i ask here before waste my time.

thanks

 

No unfortunately a new Config with a MPG already included did not do the trick.
Manual jogging the X and Z axes works, continuos and inkremental but not with the encoder I intend to use as MPG.
I once again ran the suggested command "halcmd show pin | grep jog" - report attached.
Did not imagine it would be this challenging to get a MPG connected...
Sigi

 

You have the host set to the same address as the 7I96 card
(so you are pinging your host PC)

For a 7I96S set to 192.168.1.121, use 192.168.1.100/24 for the host 

For a 7I96S set to 10.10.10.10, use 10.10.10.100/24 for the host

( 10.10.10.10 is suggested rather than 192.168.1.121 as the 192.168.1.XX
range is often overlapped with local DHCP network addresses)

Try:

mesaflash --device ethernet --addr 192.168.1.121 --readhmid

use raspbery pi pico 

Die ganze fehler?
Gibt "raspi" dabei?

Hallo
Ich habe  LinuxCNC 2.9.4 Debian 12 Buchwurm PREEMPT-RT ISO neu installiert
und bekomme von  Sudo apt Upgrade eine Fehlermeldung:
Fehler traten auf beim Bearbeiten von:
 linux-image-6.1.0-37-rt-amd64
 linux-image-rt-amd64
 initramfs-tools
E: Sub-process /usr/bin/dpkg returned an error code (1)
 Ich habe auf einen Zweiten Rechner Linuxcnc installiert  und bekomme die selbe Fehlermeldung

was soll ich tun
mfg
Hilton
 

I have enter this setup but there is communication problem.
In thw VFD display seems F399.9 message, and the CB1241 in S7 1200 blink TX and RX leds slow
What can I do please?