Advanced Search

Tried several times , Bios is correct settings , will not boot with the ISO . The machine will run with the other machines control plugged in . I posted a zip of the backup files. But there seems to be alot of extra files.

It seems to work better while it works, but it shortly stops and the parallel port becomes disabled, and I have to reboot. The pausing problem stopped and the latency is much better, but it gets disabled pretty quickly

avalon 841

www.linuxcnc.org/iso/ubuntu-10.04-linuxcnc3-i386.iso
Download, burn to USB, boot from that USB in LIVE mode, open file browser, insert the USB with the backup files, find the .ini file, right click on it and choose "open with", type emc2 or linuxcnc below, hit enter.
Does the machine run properly?

To be Honest , I don't have the ability ,capability, or the time for a new configure. The system is password protected. I've tried to boot to a USB with the ISO on it . But the protection wont let me. So I cant do a fresh install.

I’m using the latest versiin of linuxcnc. I tried a new config before posting but got an error when launching qtplasmac. I will try again and post the error here. Thanks.

You can also get a list of all enabled hardware pins with:

halcmd show all | grep hm2

When LinuxCNC is running.

I'm recalling a message where I stated that the problem was solved. It is not. I'm attaching the present state of the relevant .ini and .hal files.

Hi,

How are you?

How are you progressing with this, did you get it to install successfully?

If your current hal file is like the older one, enable is
controlled by joint.N.amp-enable-out. This will be true anytime
LinuxCNC is in the run state. 

From the older hal file:

net x-enable <= joint.1.amp-enable-out
net x-enable => hm2_7i76.0.stepgen.01.enable
net x-enable => hm2_7i76.0.7i76.0.0.output-01


Didn't you mention that you had DMM drives?

AFAICR, these are disabled when the enable input is powered.

Hi, please share your LinuxCNC hal and ini files. Is the remora ethernet component loaded?

github.com/scottalford75/Remora-RT1052-c...omponents/Remora-eth

A better question I should ask is what kind of response or voltage should I see on the ENA pin when the jog is made? It's looks to be 24V and not changing.

Thanks

i successfully updated to 2.9.4.  My pins are labeled as 7i76e now but i believe that is due to me picking 7i76 instead of 7i76e in pncconf. 

However, I'm still not getting the motors to move.  It's changing the DRO and display in Axis.  I see voltage changes in Dir and Step pins but nothing changes.
Any ideas?

Thanks

Have anyone found a solution? I have the same problem with a Dell S2240T touchscreen, no double click or any clicks in QTdragonHD

Managed to get info by making a test config in MesaCT and then look in I/O.hal

Input 16, TB5
hm2_7i95.0.inmux.00.input-16