Another plasma component...

Hmm, getting an error here when running linuxcnc on my config and the plasmac gmocappy sim

the rip-environment seems to be correctly pointing to linuxcnc-dev

False alarm, on reboot it seems OK. Shame about a home switch not working though

Great job Phill,

Does this mean that soon PlasmaC will be included with the basic Linuxcnc install? as in the ISO install file?

I have one more question, I have gotten as far as running a program but when the torch goes to pierce it fires and just stays still at the pierce point and does not move, Is there a setting I am not seeing that is stopping the motion.

It won't be in the ISO, they only put the current stable branch there which is currently 2.7

Do you get any error messages?

Does the Arc OK LED turn On?

Check the Fail Timeout value in the Config tab.

EDIT: It is easy to get an ISO installed system to point to the buildbot to run master branch

thefabricator03 wrote: Great job Phill,

Does this mean that soon PlasmaC will be included with the basic Linuxcnc install? as in the ISO install file?

I have one more question, I have gotten as far as running a program but when the torch goes to pierce it fires and just stays still at the pierce point and does not move, Is there a setting I am not seeing that is stopping the motion.

Plasmac will be part of the distribution when V 2.9 becomes the release version and we have not released 2.8 quite yet!
But its a trivial matter to upgrade from the release version to master from within the Synaptic package manager. Its so long, I've forgotten how to do it!

Your lack of motion could be something to do with the spindle.0.at-speed pin.

So if you have a spindle, you set this pin to be true when your spindle is at speed. Motion is inhibited until this happens! We used to just fudge it and turn it on for ever but I'm not sure how Plasmac does it as I'm sure it won't set it true until its ready to go so best wait for phill

Can you post your HAL file.

If Rod is correct I may need to get the configurator to comment out some of the spindle stuff.

I forgot pncconf gives you a spindle regardless of whether you want it or not. It is really for mills or lathes.

I hand code my HAL files so I don't think of all these eventualities...