Another plasma component...

phillc54 wrote: Can you post your HAL file.

If Rod is correct I may need to get the configurator to comment out some of the spindle stuff.

I forgot pncconf gives you a spindle regardless of whether you want it or not. It is really for mills or lathes.

I hand code my HAL files so I don't think of all these eventualities...

Phill,

Please find attached my Hal file,

I do have a Arc Ok signal then after about 3 seconds it times out and I get a valid arc lost program paused error.

Could you try this one.

Same thing Phill,

But this time the corner lock button lights up.

Could someone post a working Gcode file of anything for PlasmaC and I will see if it is my post processor that is causing the problem.

Before you run it open HalShow and watch the pin spindle.0.at-speed

I think the HAL file you sent me should work as is...