Py3 - Probe Basic Config Conversion Doc Lcnc 2.9+

I tried to run it without this file.
The error no longer appears, but the program still doesn't start.
I'm sending a screenshot of the report.

Nothing showing there, go up a bit and take another screenshot.

Comment out the intro graphic line in the display section

Lcvette wrote:

Comment out the intro graphic line in the display section

I missed that, sorry.
Was looking for complicated stuff, as usuall.

tommylight wrote:

Lcvette wrote:

Comment out the intro graphic line in the display section
I missed that, sorry.
Was looking for complicated stuff, as usuall.

im the same way..lol i oft miss the forest for the trees when bug hunting..

In my ini. file, there was no such line at all.
I had to remove INTRO_GRAPHIC before. After adding it, the message in the report disappears.
Commenting out this line, of course, causes the message about looking for this line to appear. Overall, the program still does not start. It seems that this is not the main cause.
I attach the last screenshot report and the ini file.