LinuxCNC + Orange Pi (allwincnc)

Which H5 board do you have? It's currently difficult to get any H3/H5/H6 or A64 hardware.

I just spotted these on Amazon with 2GB of RAM for only $40:   www.amazon.com/Libre-Computer-Board-ALL-...ritium/dp/B07D4KTRWR

Orange Pi Prime. They are avaliable where I live. They can be used on real world hardware?

This is all still in Beta.

I purchased one of these H5. Wanna try it on real hardware CNC. By usable I mean... It loses steps, or have any serious bug that would prevent for being used? I'm avid to use it! I've been searching for an example of it working on a real machine but haven't found anything. 

Thanks for this awesome work! I

The last post specifically about the H5 forum.linuxcnc.org/18-computer/39037-lin...cnc?start=150#208831

I only have an older 512MB H3 board.

So, I guess no ARISC support in H5 at this moment. I should've picked an H3 but thought 512 MB RAM would be too low to run x server and axis. Anyway, I would be glad in doing tests and reporting back. If needed, count on me. I have a fully assembled machine to this.