My 7i76e Connection Sheet

when i send a ping to the mesa card the led's react so i think i reach the mesa card
also when i send the command "sudo mesaflach --device 7i76e addr 10.10.10.10 --readhmid" the led's of the mesa are blinking for a while but got the replay "no 7i76e board found"
can it be a good idea to reinstall with the version 2.8 ?

fons wrote: when i ping loopbach the pc i got 0.015msec
i set the adress of the pc to 10.10.10.11
i install the linuxcnc-2.7.14-wheezy.iso on a pc that is only for cnc using

Ok the address is good, but the Linux version is not for use with Mesa ethernet boards.
Use this
www.linuxcnc.org/iso/linuxcnc-2.8.0-buster.iso

thankyou very much i will download it and install it again with 2.8
a quick question when a stepper motor had a torque of 12nm do it mean its the working torque or the holding torque and whats the relation between both

Holding torque, working torque will decrease with rotational speed.

got the linuxcnc 2.8 running i don't want the parralel poort config what is eazy to understand what to fill in where
for the pnconfig its not that clear anymore much more to fill in
i like to setup en 3axe mill with stepper motor nema17 and tb6600 driver limit switch single mpg for the 3axe (rotaryswitch) this is for now a test case
can i find somewhere a tutorial for these config ?

do someone had make such a set up ? and can guide me one time true the pncconfig ?
what do i have to fill in where
what are the meaning of the variable and how inportant are they to do what ?