New Project with Mesa 7I96 and THCAD-05

Well will have to wait on this ohmic part cause I am running a job that is a little bigger than my 2 inch test circles I was doing a couple of days ago and it looks like the THC is not working it’s not moving up or down. I see the voltage marking on the GUI and I am using the latest sheetcam plasmaC file that is in the sheetcam drop down.

TexasCNC wrote: I see your comp file am I suppose to add that to my config file directory?

It does not really matter as it will install from any folder but it would be best to keep it all together

TexasCNC wrote: Well will have to wait on this ohmic part cause I am running a job that is a little bigger than my 2 inch test circles I was doing a couple of days ago and it looks like the THC is not working it’s not moving up or down. I see the voltage marking on the GUI and I am using the latest sheetcam plasmaC file that is in the sheetcam drop down.

You do have the THC enabled in the GUI don't you?

Yes it’s enabled and the the auto volts is also enabled as well.

Check the value of :
plasmac.thc-feed-rate
it should not be 0

I don’t see that in any of of my files for ini or Hal

Use halshow or hal meter