New Project with Mesa 7I96 and THCAD-05

TexasCNC wrote: Well I finally figure it out and i knows it was going to something simple and it was something I didn’t have to do on my other table and it was to GROUND the ground side of my 24v power supply to my table frame and the flickering stopped.

Was that on the AC side or DC side?

rodw wrote:

TexasCNC wrote: Well I finally figure it out and i knows it was going to something simple and it was something I didn’t have to do on my other table and it was to GROUND the ground side of my 24v power supply to my table frame and the flickering stopped.

Was that on the AC side or DC side?

DC side I have a + bus bar and a - bus bar off of my 24v power supply I grounded the - bus bar to table frame and that stopped the flickering. I knew it was grounding issue just thought it was coming off the plasma.

Clive S wrote:

TexasCNC wrote: Can somebody post the working sheetcam post processor file the ones I see on the other threads are for other programs and don’t see any for sheetcam

The latest win version of SHEETCAM has the PP built in

So the one already in sheetcam program should work with plasmaC?

TexasCNC wrote:

Clive S wrote:

TexasCNC wrote: Can somebody post the working sheetcam post processor file the ones I see on the other threads are for other programs and don’t see any for sheetcam

The latest win version of SHEETCAM has the PP built in

So the one already in sheetcam program should work with plasmaC?

Awesome thanks

I got the machine cutting and working still need to tune some minor details but so far working.
I have the thcad-05 and was trying to hook this up but was trying to see where they are hooking up the output to from board to circuit?