Upgraded to 2.7.13 -- W T F --

No, I am saying that the backup config does not seem to be able to find the lathemacro files.

(Seeing the output of starting the main config might be useful)

forum.linuxcnc.org/9-installing-linuxcnc...-t-f?start=10#111967

7i76 error is in both main and backup!

tecno wrote: forum.linuxcnc.org/9-installing-linuxcnc...-t-f?start=10#111967

That config appears not to have a problem finding the lathe macros, so I think there was a problem with relative paths from the backup config.

However that then does seem to have a worse problem with Gtk after that point.

If you comment-out the line in the INI that loads the lathe macros, then start the main config are things any better?
(I am wondering if an update to Gtk or similar is causing problems)

I will give that a whirl later on today, thanks for your help Andy

todays ini and hal